No outside builder
We put the building up ourselves; no outside contractor is needed for the steel.
A common mistake with custom metal buildings in Summerville, SC is to take the word custom on trust. Every seller uses it, so ask which parts you can actually change: width, height and the openings should all be set for your lot. Buyers here get plant-direct steel, roll-formed by us in Farmville, NC, and you can look over a footprint beforehand at our walk-in lot in Greenville, NC. Our delivery and installation area takes in the Charleston corridor, Dorchester County and the nearby towns of Eastern South Carolina, and for the steel building you need no separate builder. Dollar figures are not posted online, so call (252) 414-5105 or use the quote form.
Call (252) 414-5105
Get a Free Quote
Your custom metal building is made, delivered and put up by us, in Summerville and anywhere in Dorchester County. Phone (252) 414-5105.
Our quotes cover clear-span commercial space as well as carports, barns, workshops and garages. Widths, heights and openings are priced for your own pad and for what your county requires, with wind and humidity as they are on the coastal plain taken into account.
Nothing is manufactured in Greenville; the work happens in Farmville, NC. To see samples first, walk the Greenville lot. Orders then travel to Summerville and the Charleston corridor. You can reach East Carolina Outdoor Products at 1046 Greenville Blvd SW, Greenville, NC 27834, or by phone at (252) 414-5105.
Nearby towns we serve include Charleston, North Charleston, Ladson, Goose Creek, Moncks Corner, Ridgeville, Harleyville, Walterboro, Conway, Florence and the Myrtle Beach corridor, along with other Eastern SC towns inside our free delivery range. If you are comparing buildings for sale, kits or rent-to-own, ask about those as well; qualifying buildings need no credit check.
Every seller calls a building custom, so ask which parts can really change. Can you set the width, the length and the height of the legs in small steps, or only pick from a few stock sizes? Door and window positions should follow your driveway and your routine rather than a fixed plan. And the framing and anchoring ought to be engineered for your own county instead of lifted from a catalog.
Coastal sites make that last item the most important, because design wind speeds run higher near the water and an inspector will want certified drawings showing the address on your permit. A lean-to is where custom saves the most money: leaving one side open for the boat, the tractor or the woodpile adds covered space at a fraction of the cost of widening the building.
Begin with a rough drawing of your lot showing the driveway, the direction the weather arrives from and everything the building must hold. We can work from it, and the 3D designer lets you try out a layout beforehand.
Summerville goes by the Flower Town in the Pines, and it lies inland from Charleston, in Dorchester County. On the South Carolina coast, the rules come from wind and water. Winds used for design are some of the strongest in the region, and plenty of lots fall inside mapped flood zones, so before you pick colors or door sizes, deal with pad height, anchoring and certification. Ask for certified drawings early; the departments that issue permits here expect to see them.
Hugo in 1989 is the storm everything is compared with. Matthew and Florence later taught the other lesson: rising water can be as destructive as wind, and days after Florence had gone, the Waccamaw was still climbing. Day to day, the wear comes from salt in the air. A regular rinse, touch-ups to trim and fasteners and a roof profile that does not hold debris keep steel looking its best for decades. Sand drains quickly, yet anchors still have to be chosen for it, so describe your soil when you request a quote.
Yes. The steel is made in Farmville, NC, and we deliver it to Summerville or anywhere in Dorchester County and put it up there. Call (252) 414-5105.
No. The steel building is built and installed by us, so no second contractor is involved. Call (252) 414-5105.
In Farmville, NC. Greenville has a walk-in lot only; nothing is built there.
Size, options and certification all affect the price, and dollar figures are not published online. Call (252) 414-5105 or use the quote form.
Describe the building you want, the county it will stand in and what it will hold. We price from current steel costs, nothing obliges you to go ahead, and we will point out a better-fitting size if there is one.