Metal Building Kits Roanoke Rapids, NC

Tan metal garage with two roll-up doors and side lean-tos

Roanoke Rapids NC · Metal Building Kits

You can check the key facts about metal building kits for Roanoke Rapids, NC before you commit. The steel is 29-gauge and comes off the roll-forming line at our Farmville plant. The Greenville lot, at 1046 Greenville Blvd SW, lets you walk a building’s footprint before it is delivered to Roanoke Rapids and Halifax County. And a real quote comes from a phone call or the quote form, since no dollar figures are posted online.

Buyers here usually want either a kit or turnkey steel for a pad in Halifax County close to I-95. With turnkey, ECOP builds and installs the building, so the steel needs no separate contractor, and delivery and setup cost nothing within 100 miles, a radius that reaches across Eastern NC, SC and VA.

Call (252) 414-5105

Get a Free Quote
Reputation and Trust

No builder to hire

On turnkey orders our team handles the construction and the installation, so there is no outside contractor for the steel.

power 2

Made in Farmville

Manufacturing and roll-forming happen at the Farmville plant. Greenville does not manufacture anything.

Locations

Walk-in lot in Greenville

Located at 1046 Greenville Blvd SW.

Support

Call us

(252) 414-5105 reaches us.

delivery truck

Free delivery and setup

No charge for sites inside a 100 mile radius of our lots and the plant.

money_1

Rent-to-own

No credit check is run on buildings that qualify for rent-to-own.

Customize

Custom metal buildings

We set the widths, heights and openings to suit your site.

Customize

Metal building kits

Our clear-span kits come with a price made for your particular site.

Relocated

Kit or turnkey

Materials only, or ECOP supply-and-erect: you pick how much of the work you take on.

Steel frame of a metal building going up, with a lift on site

Materials only, or we build it

A kit can be bought as materials only, or as a full ECOP supply-and-erect order. With the supply-and-erect package there is nobody else to hire for the steel. Phone (252) 414-5105.

ECOPM35

Metal building kits for Halifax County pads

Each kit package holds panels, framing and hardware. Close to I-95 you can also have ECOP supply and erect it, and certified packages are available whenever Halifax County or your insurer asks for certification.

White metal building with open bays, with a truck and equipment trailer nearby

Plant in Farmville, lot in Greenville, delivery to Roanoke Rapids

Manufacturing and roll-forming stay in Farmville, and nothing is made in Greenville. The Greenville lot takes walk-in visits and carries our address: East Carolina Outdoor Products, 1046 Greenville Blvd SW, Greenville, NC 27834. Once you have seen a sample there, we bring the building to Roanoke Rapids. Reach us at (252) 414-5105.

White metal building with a new concrete apron

Where we deliver every day near Roanoke Rapids

Rocky Mount, Emporia VA, Littleton, Gaston and Weldon, along with other Eastern NC towns, all fall inside the free delivery range. Ask about kits, buildings for sale and rent-to-own; qualifying buildings need no credit check.

Very long white metal building with black wainscot

Is a metal building kit right for your Roanoke Rapids site?

A kit saves money when you can supply three things yourself: time, helpers and tools. Before ordering, take a hard look at the ground. Squaring and leveling a steel frame is hardest on loose sand, soft soil or a slope, and those are the sites where owner-built kits tend to fail; a frame that starts crooked makes each panel after it a fight.

Then there is anchoring. The right anchor depends on the base, whether concrete, asphalt or bare soil, and on the loads Halifax County requires. If a permit applies, the inspector will compare the finished building with the certified drawings, and that includes the anchors.

If the list looks long, hire us to do it. Installation takes that risk off your hands, and your weekend goes to using the building.

Gray barn-style metal garage with two doors and side lean-tos

Storms, soil and anchoring around Roanoke Rapids

Two storms stand out here: Floyd, in 1999, and Matthew, in 2016. Both came this far inland as rain, and both sent the Tar and Neuse rivers over their banks for days. For siting, the lesson is to start with water and anchor for the soil, not for wind alone.

The land makes the point. Roanoke Rapids lies where the Roanoke River reaches the fall line, close to I-95 and below the Virginia border. Like the rest of the inner coastal plain, the soil is sandy loam lying over clay on level ground, with groundwater nearer the top than newcomers expect. Sweet potatoes and tobacco thrive in that. A slab set in the lowest part of the lot does not, so after a summer downpour, see where the water stands and put the building elsewhere.

Wind is a factor, yet for most of Halifax County the questions that count are drainage, a pad that carries rain away and anchors chosen for the soil. If a creek or river runs near the lot, check the county flood map first; the lookup is quick, about five minutes, and it can spare you an insurance headache.

Specifications

  • Plant: Farmville, NC — roll-forming manufacturer
  • Walk-in lot: 1046 Greenville Blvd SW
  • NAP: East Carolina Outdoor Products, 1046 Greenville Blvd SW, Greenville, NC 27834
  • Phone: (252) 414-5105
  • Panels: 29-gauge standard, 26-gauge upgrade
  • Widths: 12’–60′ clear span
  • Service: Roanoke Rapids · Halifax County · Eastern NC
  • Delivery: Free within 100 miles
  • Region: Eastern NC · Eastern SC · Eastern VA

Common Questions

Who supplies metal building kits to Roanoke Rapids, NC?

ECOP does. We manufacture in Farmville, keep a walk-in lot in Greenville, and deliver and install around Halifax County as well as in Roanoke Rapids itself. Phone (252) 414-5105.

Will I need to bring in my own builder if I buy a kit?

Not if ECOP supplies and erects it. In that case we build and install the steel building ourselves, so there is nobody else to hire for it. Phone (252) 414-5105.

Is the Greenville lot where the kits are made?

No. The kits are made at the plant in Farmville, and the Greenville lot only receives walk-in visitors.

What will a metal building kit cost me in Roanoke Rapids?

That depends on the size, the height, the doors and the certification. Dollar figures stay off our website, so ask by phone at (252) 414-5105 or through the quote form.

Is rent-to-own available without a credit check?

Yes, on buildings that qualify. Mention it when you call or send the quote form.

Send the details, get a price within 24 hours

Tell us roughly how big, which county, and what is going inside. We price from the cost of steel today, there is no obligation, and a better-fitting size gets a mention if there is one.

Request a Quote Design It in 3D