Metal Carports Plymouth, NC

Open metal carport on a concrete pad

Plymouth NC — Steel Carports

You can check most of what matters about a metal carport in Plymouth, NC before you spend anything. The steel is roll-formed at our plant in Farmville, the sales lot is at 1046 Greenville Blvd SW in Greenville, and the number for a quote is (252) 414-5105. The carports shelter everything from a daily driver to a farm truck or an RV on properties across Washington County, and delivery and installation are free inside 100 miles. For longer runs, storms along the river corridor favor a vertical roof. Our crew handles manufacturing, delivery and setup, so the steel itself needs no outside builder.

Call (252) 414-5105

Get a Free Quote
Relocated

We build and install

The steel building needs no separate contractor, because our crew puts it up.

Support

Call to order

(252) 414-5105 is our number for questions and quotes.

power 2

Steel from our plant

Our Farmville plant rolls the steel; the Greenville lots only sell it.

Locations

Greenville sales lot

Find us at 1046 Greenville Blvd SW.

Customize

Roof style options

Vertical, boxed eave or regular.

delivery truck

Free delivery and setup

Delivery and installation cost nothing inside 100 miles.

money_1

Rent-to-own available

No credit check is needed to rent a qualifying unit to own.

Steel frame of a metal building going up, with a lift on site

We build it and install it, so you hire no one else

One company manufactures, delivers and sets up the metal building, which leaves nobody else to hire for the steel itself. Questions go to (252) 414-5105.

White and gray metal building with arched open bays

Metal carports for Plymouth and Washington County

Roanoke River farms, and the long driveways near Creswell and Roper, call for covered parking rather than a full enclosed garage. We quote the framing and roof style for sites in Plymouth, NC, and we recommend vertical roofs on longer runs, which catch the storms of Eastern NC.

Aerial view of a dark metal roof with a covered porch

Which roof: vertical, boxed eave or regular

Past 20′ of run, vertical roofs shed rain better. Let us know whether the carport will cover a truck, a tractor, a boat or a coach, and we will pick legs tall enough to clear it with room to spare.

White metal building with open bays, with a truck and equipment trailer nearby

Delivery and setup at your site

Farmville ships free inside a 100-mile radius. To reach East Carolina Outdoor Products, dial (252) 414-5105 or stop by the walk-in lot at 1046 Greenville Blvd SW, Greenville, NC 27834.

White metal garage with cars parked in three open bays

A carport against pollen, sap, sun and hail in Plymouth

Spring in Plymouth brings yellow pine pollen. Sap and needles take over for the rest of the year. In summer the sun can cook a dashboard, and an afternoon thunderstorm may drop hail. A carport covers a vehicle against all four, and it costs less than any other steel building.

When you order, a few specifications do most of the work. Roof: vertical, so needles, leaves and rain slide off instead of staying put. Legs: a foot or two taller than today’s vehicle needs, which adds little to the price and means a small camper, or a truck carrying a rack, still fits later. Sides: panels on the side the weather comes from, to stop rain being driven in. And near the coast, ask us whether the building needs wind certification and how it should be anchored, since an open-sided roof catches the wind much as a sail does.

White metal building with a porch on a new concrete pad

Plymouth soil, drainage and where the pad goes

The ground comes first. Water shapes this corner of the state, from the Albemarle and Pamlico sounds to the Roanoke, Pasquotank, Chowan and Pamlico rivers, with low, flat farmland between. Soil is a mix of sandy ridges and black organic ground that holds water much as a sponge does. Put the pad where it can be raised, compacted and graded so water runs away from it; few places we deliver reward a well-built pad as much as this one.

Before you settle on a location, see where the parcel sits on the flood map. Storms here mostly come as wind-driven water: Isabel (2003) and Irene (2011) each sent the sounds across yards and fields a long way from the shore. Near the shoreline, the county can say whether a CAMA permit applies; the counties that ring the sounds are mostly under the state’s coastal management rules.

Open country means room, too. Plymouth lies in Washington County beside the Roanoke River, and the town holds the North Carolina Black Bear Festival every summer. Farmers growing peanuts, cotton and soybeans nearby have relied on steel buildings with wide, clear spans for decades.

Specifications

  • Plant: Farmville, NC
  • Phone: (252) 414-5105
  • Sales lots: East Carolina Outdoor Products, 1046 Greenville Blvd SW, Greenville, NC 27834
  • Roof: Regular / boxed eave / vertical
  • Delivery: Free within 100 miles
  • Hours: Mon–Fri 9am–5pm, Sat 9am–1pm

Common Questions

If I order an ECOP metal building, do I need to find my own contractor?

Not for the steel itself. We manufacture the building, bring it out and set it up, and (252) 414-5105 is the number for any questions.

Where do I go to buy a metal carport for my place in Plymouth, NC?

Call (252) 414-5105. We make the carport in Farmville and our crew sets it up on your Plymouth property; to look at samples first, walk the Greenville lot.

Which roof style should I choose for a carport in Plymouth?

Pick vertical if the run is long, since rain and debris clear off it more readily. Boxed eave is the one with a residential look. We can quote either from Farmville.

Is it possible to get an RV carport installed near Plymouth?

Yes. We need the coach’s height and length first; with those two figures we can size the carport properly and then quote.

Are the carports manufactured at the Greenville lot?

No. Manufacturing happens in Farmville; the Greenville lot exists for sales.

A real figure for your carport in 24 hours

Tell us the size, your county and what will sit underneath. Pricing follows current steel costs and there is no obligation. If another size would suit you better, we will say so.

Request a Quote Design It in 3D